Ultrawideband Single-Pass Interferometric SAR Integrated with Multi-Rotor UAV


Student Name: Lee Taylor
Defense Date:
Location: Nichols Hall, Room 317 (Richard K. Moore Conference Room)
Chair: Carl Leuschen

Shannon Blunt

Patrick McCormick

John Paden

Fernando Rodriguez-Morales

Emily Arnold

Abstract:

Ultrawideband (UWB) Interferometric Synthetic Aperture Radar (InSAR) integrated with multi-rotor Uncrewed Aerial Vehicle (UAV), or UIMU in this work for brevity, provides ultrafine-resolution, all-weather, three-dimensional (3D) surface imagery at any time of day. UIMU can be rapidly deployed and is low-cost, and therefore a critical new tool for low-altitude remote sensing applications, such as disaster response, environmental monitoring, and intelligence, surveillance, and reconnaissance (ISR). Traditional repeat-pass data collection methods reduce the phase coherence required for InSAR processing of ultrafine-resolution datasets due to the unstable flight behavior of multi-rotor UAVs. Collecting Synthetic Aperture Radar (SAR) datasets using two receive channels during a single pass improves phase coherence and the ability to produce ultrafine-resolution 3D InSAR imagery.

This work quantifies and characterizes the 3D target-position accuracy of a dual-channel 6 GHz bandwidth (2.5 cm slant range resolution) frequency modulated continuous wave (FMCW) radar integrated with the Aurelia X6 hexacopter, establishing novel single-pass UWB InSAR data collection methods and processing algorithms for multi-rotor UAVs. Building on earlier qualitative single-pass InSAR imagery that demonstrated the feasibility of the approach, fieldwork was conducted to measure the positions of Global Navigation Satellite System (GNSS) located corner reflectors using the UIMU system. Algorithms for motion tolerant Time-Domain Backprojection (TDBP), InSAR coregistration, and digital elevation mapping, novel to multi-rotor UAVs at UWB, were developed and are presented, and the TDBP imagery is compared with conventional frequency-domain Omega-K processing. The effect of vehicle motion on the synthetic aperture is investigated. The results show that UIMU is possible, with calibration of the signal processing workflow being of utmost importance: the radar, the GNSS logger and the flight log must be aligned closely in time, because the position and attitude of the vehicle vary rapidly over short time scales and coherence is quickly lost as the position or alignment error grows. The internal delay and phase of the radar must also be precisely calibrated. With these calibrations, single-pass interferometry from the multi-rotor UAV is achieved: both corner reflectors focus over a 27 m synthetic aperture, and the interferometrically detected height difference between the two reflectors, 0.28 ± 0.08 m, falls within 3 cm of their surveyed 0.25 m height offset. The radar-measured reflector positions differ from the in-situ real-time kinematic (RTK) GNSS positions by about 25 cm in ground range, at a ground range resolution of about 3.5 cm; this difference is largely attributed to sensitivity to calibration and to the precision of the radar antenna positions. Using one RTK reference point for the ground height, the radar-measured ground elevations agree with the in-situ RTK measurements to within 0.20 m rms and lie 0.2 to 0.6 m above the TessaDEM global elevation model. Centimeter-scale error sources behind a 6.5 cm residual slant range offset and the remaining loss of focus are investigated, estimating how sensitive UIMU is to calibration errors, to errors in the lever arms to the antenna phase centers, and to errors in the measured vehicle position and attitude, which shift and defocus the image.

This work establishes a foundation for future investigations of real-time image processing, separated transmit and receive platforms (bistatic), and swarm configurations for UIMU systems.

Degree: PhD Dissertation Defense (EE)
Degree Type: PhD Dissertation Defense
Degree Field: Electrical Engineering